HOME Deutsch |    HOME English

Technical details: TRM/416 Series
Case / Cabinet Versions

Open frame = without case. Direct access to the hardware for the base board on the backside. Designed as evaluation version (for development) or for mounting the system inside your target hardware, e.g. inside machines, vehicles, cases / cabinets etc.

Note: current deliver versions of the front panel do not include thread needle pins on the backside of the front panel plate. We recommend to use our MOUNTING FRAME for easy mounting the the open frame system! (See MOUNTING FRAME below on this page!)

See bigger picture of the backside TRM416: Base Board BB416 Rear View**

For Open Frame Systems: Special Cable Kit Page!

Section 2: Extended Case / Cabinet Version with more IO interfaces
Ordercode: TRM/416-IP65-WM-EXT Case

Note: Connector description can vary!

IP protected metal case, slim line version, with 3x SUB D9 connectors for interfaces. IP65 protection (IP65 = water / dust protection) front and side. Note: Shown standard connectors does not include IP protection. Special protected connectors available in customized versions!) System for roughly environment. Optionally: With four (4) wall mounting brackets.

IO connector list TRM/416-IP65-WM-EXT case version:

• RJ45: Ethernet LAN Networking
• DIN: Power (Note: TRM/xx systems in case need special power supply with DIN connector. Ordercode: PWR4-TRM-SCREW. Please refer option and pricelist for details.
• SUB D9 male connector No 1: serial port COM1 / RS232
• SUB D9 male connector No 2: available with function for CAN or COM2 or DIO (digital IO).
  Standard using is CAN interface.
  Additionally options: TRM-DIO-SUBD1 uses DIO instead CAN.
• SUB D9 male connector No 3: serial port COM 2 / RS232

Note: A cable kit for connectors is included with the ordercode. This means, if you order the TRM/xx with this case, there is no need to order extra cables!

Picture above shows TRM/xx-IP65-WM case with vehicle holder, e.g. for car / vehicle mounting. It is designed for TRM/xx series together with IP65 slim line case.

Description: A metallic backplate is mounted on the backside of the TRM/xx case. An adjustable holder is mounted in the car / vehicle: the TRM/xx snaps in easily. The holder is adjustable for the best viewing angle from the user. The holder and special holder backplate are options and not in standard cases. See following pictures for details:

TRM system as shown in section 1 (open frame) - but without labeled front panel. With "naked" key front panel only. Ideal for printing your own front panel and fix it in front of the keys... 

System in TRM/xx-IP65 case for DIN rail mounting. DIN rail connectors backwards in IP case.